CKM Servocylinder (magnetosonic programmable)

Subplates

Incorporated subplates allow the direct mounting of the valves on the cylinder. For strokes shorter than 150 mm, the cylinder will be provided with suitable spacers.

NONE

Without subplates

10

ISO 4401 size 06
Bore ø 40 ÷ 200 mm

20

ISO 4401 size 10
Bore ø 40 ÷ 200 mm

30

ISO 4401 size 16
Bore ø 80 ÷ 200 mm

40

ISO 4401 size 25
Bore ø 125 ÷ 200 mm

Bore size (mm)

Rod diameter (mm)

28

36

45

56

70

90

110

140

Stroke (mm)

The stroke is the maximum displacement of the piston rod. Specify the desired stroke entering the value in the field provided

Please select a value between the range

Select a value between 25 and 3000 with step 5 and confirm to continue

Mounting style

For mounting style L and strokes shorter than 35 mm, the configured cylinder is automatically equipped with a spacer, minimum length 50 mm. Spacers length selection will be available in subsequent configuration steps.

X

Basic execution

A

Front round flange (Ref. ISO MF3)

B

Rear round flange (Ref. ISO MF4)

C

Fixed clevis (Ref. ISO MP1)

D

Fixed eye (Ref. ISO MP3)

E

Feet (Ref. ISO MS2)

G

Front trunnion (Ref. ISO MT1)

H

Rear trunnion (Ref. ISO MT2)

K

L

Intermediate trunnion (Ref. ISO MT4)

N

Front flange (Ref. ISO ME5)

P

Rear flange (Ref. ISO ME6)

S

Fixed eye with spherical bearing (Ref. ISO MP5)

T

Threaded holes with tie rods extended (Ref. ISO MX7)

V

Rear the rods extended (Ref. ISO MX2)

W

Both end tie rods extended (Ref. ISO MX1)

Y

Front tie rods extended (Ref. ISO MX3)

Z

Front theaded holes (Ref. ISO MX5)

Cushionings

Cushionings’ profiles are designed to reduce the cylinder speed before the rod contacts the mechanical stroke-end, dissipating the energy with limited pressure spikes. These hydraulic dampers also reduce mechanical shocks. The adjustable versions are equipped with cartridge valves to increase max damping energy extracted from cushionings chart in table B015 (section 7.5) or to optimize the cushioning performances in different applications.

0

Without cushionings

1

Rear FAST adjustable

2

Front adjustable

3

Front and rear FAST adjustable

4

Rear SLOW adjustable

5

Front SLOW adjustable

6

Front and rear SLOW adjustable

7

Rear FAST fixed

8

Front FAST fixed

9

Front and rear FAST fixed

Spacers

The spacers increase the rod and piston guide to protect them from overloads and premature wear, they are recommended for strokes longer than 1000 mm in pushing working condition.
The overall dimension of the cylinder increases by a value equal to the length of the spacers.
For strokes longer than 3000 mm is recommended to contact our technical office.
Spacers are mandatory for strokes shorter than the minimum values for subplates and for mounting style “L”.